Ryobi R18N16G, Original Instructions Manual

Page: 4 / 104

English
2
leaking. Check with the forwarding company for further
advice.
INTENDED USE
The product is intended to drive nails in soft materials such
as wood. It can be used in the following:
■
Finish and Trim (Interior and exterior)
■
Door and Window Casing
■
Door Jambs
■
Baseboard
■
Crown Molding
■
Cabinetry
■
Cap and Shoe Molding
■
Molding
■
Wooden staircases
■
Door and Window Trim
■
Chair Rail
■
Brickmold
■
Hardwood Flooring
■
Paneling
■
Furniture
This product is not suitable for fi xing electric cables.
Do not use this product in any way other than those stated
for intended use.
MAINTENANCE
WARNING
The product should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product will prevent
accidental starting that could cause serious injury.
a) When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
b) Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
c) Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. They contain chemicals that can
damage, weaken or destroy plastic.
d) Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
e) For greater safety and reliability, all repairs should be
performed by an authorised service centre.
LUBRICATION
All of the bearings in the product are lubricated with a
suf
fi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
Do not use lubricants on nails, nail magazine or driving
mechanism. Keep clean.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety alert
CE conformity
EurAsian Conformity Mark.
Read operator’s manual
Depth adjustment
Full sequential actuation
Contact actuation
Fastener length
Ga Fastener gauge
Fastener diameter
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authority or
retailer for recycling advice.