Ryobi P118B, Operator'S Manual

Page: 33 / 82

6 — English
LOCK-ON BUTTON
This tool is equipped with a lock-on feature, which is
convenient for continuous operation for extended periods
of time.
To lock-on:

Depress the switch trigger.

Push in and hold the lock-on button, located on the side
of the handle.

Release the switch trigger and the tool will continue
running.

To release the lock, depress and release the switch trigger.
WARNING:
Battery tools are always in operating condition. Place the
tool in the
OFF
position when not in use or carrying at
your side. The lock-on button should not be left on when
the variable speed dial is on “0”.
ON/OFF/VARIABLE SPEED
See Figure 1, page 9.

The tool is in the OFF position when the variable speed
dial is turned fully clockwise to “0”.
NOTE: You should feel the dial click into the detent when
the dial is turned to the OFF position.

The tool will not start if the dial is in the OFF position.

To turn the tool ON , rotate the dial counterclockwise.

Continue turning the dial counterclockwise to select higher
speeds.

Turn the dial clockwise to decrease speed.

Pull the switch trigger to begin operation.

To stop the tool, release the switch trigger. Turn the dial
fully clockwise to the OFF position.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 2, page 9.

Release the switch trigger.

Turn the variable speed dial to “0”.

Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.

Depress the latch to release and remove the battery pack.
For complete charging instructions, see the operator’s man-
uals for your battery pack and charger.
INSTALLING ACCESSORIES
See Figures 3 - 4, page 9.
 Remove the battery pack.

Using the hex key provided, rotate the screw counter-
clockwise. Remove the screw and washer assembly and
set aside.
 Place the desired accessory on the head so that the
openings on the accessory fit on the raised parts of the
head. Reinstall the screw and washer and tighten securely.
NOTE: An adaptor may be needed to properly fit some
accessories for your multitool. If this applies to your
multitool, call 1-800-525-2579
. A storage area for the
adaptor is located in the battery foot.
NOTE:
Always follow the instructions for the accessory,
in addition to all instructions for this product.
WARNING:
Do not wear loose clothing or jewelry when operating
this tool. They could get caught in moving parts causing
serious injury. Keep head away from tool and work area.
Hair could be drawn into tool causing serious injury.
Accessory Type Uses
Wood blade Straight cutting in wood and plastic
Detail sanding
backing pad
Sanding in corners and other hard-to-reach areas
Sanding sheets Various sanding applications