Ryobi GD125, Operator'S Manual

Page: 32 / 172

32 - English
Screw
Pencil

Insert a flat head screwdriver into the tabs on the indoor
keypad and remove the back cover.

Hold the back cover against the wall. Use a pencil and a
level to mark screw hole placement.

Mount the back cover to the wall using screws. Install
screws using Phillips screwdriver.
NOTE: Use screws and drywall anchors when installing
the keypad into drywall.

Fit the wires included with the indoor keypad into the
notch on the keypad.

Connect the keypad to the back cover. Be careful not to
damage the wires.

Route the wires from the keypad to the keypad wire
terminals. Attach the wires to the wall and ceiling using
the insulated staples.

Insert the red striped wire from the keypad into the left
keypad terminal marked with R.
Fig. 60
Fig. 61
Notch
Back
Cover

Insert the white wire into the right terminal marked with W.
WARNING:
The entrapment warning label contains important safety
information. Install entrapment warning label next to the
indoor keypad in a prominent location. Use insulated
staples or other mechanical means if the label will not
adhere to the wall.

For details about using the indoor keypad, see Using the
Indoor Keypad in the Operations section.
Child can become trappe
d or pinned under an auto
matic garage door resulti
ng
in serious injury or death
.
• Do not allow children to
walk or run under a clos
ing door.
• Do not allow children to
operate door opener con
trols.
• Always keep a closing d
oor within sight. • In the event a person is
trapped under the door, p
ush the control button or
use the emergency rele
ase. • This operator system is
equipped with an unatte
nded operation feature. T
he
door could move unexp
ectedly. Not intended for
use with single panel ga
rage
doors.
Test door opener monthly
: • Refer to Operator’s M
anual. • Use a 1 ½ inch thick ob
ject (or 2 X 4 laid flat) pla
ced on the floor under the
closing door.
• In the event the door d
oes reverse upon contact,
adjust, repair, or replace
the
opener.
Do not remove or paint over this label.
Mount this label next to the wall control. Mount the wall control out of the reach of children at least 5 feet above the floor
.
Fig. 58
Entrapment
Label
Screws
Wire
Wire Terminal
(Keypad)
Wires
INSTALLATION
Fig. 59