3
English
GB
FR
DE
ES
IT
NL
PT
DK
SE
FI
NO
RU
PL
CZ
HU
RO
LV
LT
EE
HR
SI
SK
GR
TR
WARNING
Do not insert saw blade into air vents. They could come
in contact with electrically live internal parts and cause
electric shock, resulting in serious injury.
WARNING
Your saw should never be connected to power supply
when you are assembling parts, making adjustments,
installing or removing blades or when not in use.
Disconnecting your saw will prevent accidental starting
which could cause serious injury.
GENERAL CUTTING
See Figure 5.
Rest the front of the saw base on the workpiece and align
cutting edge of the blade with the line on your workpiece.
Make sure the power cord is out of the way of saw blade
and not in the line of cut. Start your saw and move it
forward on the work surface. Apply downward pressure to
keep the saw steady and only enough forward pressure to
keep the blade cutting.
WARNING
Do not force your saw.
Forcing your saw may overheat
the motor and break saw blades.
ORBITAL MOTION
See Figure 5.
The blade of your saw cuts in orbital motion. This feature
is adjustable and provides faster and more ef> cient
cutting. With orbital motion the blade cuts through your
work in the upstroke but does not drag across your work
in the downstroke.
Higher settings (H) should be used when fast cutting
in soft material.
Lower (L) settings should be used when cutting
materials with more resistance.
STRAIGHT CUT
See Figure 5.
A straight cut can be made by clamping a piece of wood
or straightedge to the workpiece and guiding the edge of
your saw against it. Make the cut from one direction only,
do not cut halfway to complete the cut from the opposite
end.
SCROLL CUTTING
See Figure 6.
Scroll cuts can be made with your saw by guiding the
direction of the cut with applied pressure on the handle.
WARNING
Excessive side pressure to the blade could result in
broken blades or damage to the material being cut.
ANGLE CUTTING (BEVEL CUTTING)
See Figure 7.
Bevel cutting angles may be adjusted from 0° to 45° right
or left. Angles for cuts from 0° to 45° in 15° increments
are marked on a scale on both the left and right side of
the base.
The use of a protractor is recommended when accurate
cuts are required.
ADJUSTING THE ANGLE
See Figure 3, 7.
Release the transparent guard.
Release the bevel lock lever until the base can be
moved.
Slide base forward slightly to release the base from
the tab on the motor housing.
Align the mark on the base of the desired angle with
the edge of the motor housing.
Once the desired angle is reached, slide the base
back until the tab on the motor housing aligns with the
appropriate notch on the rear of the base.
Push the bevel lock lever back to secure the base.
Install the transparent guard.
NOTE:
The transparent guard can only be used for
straight cutting.
TO MAKE A PLUNGE CUT
See Figure 8.
WARNING
To avoid loss of control, broken blades, or damage to
the material being cut, always use extreme caution
when making plunge cuts. We do not recommend
plunge cutting on materials other than wood.
Mark the line of cut clearly on the workpiece.
Set the cutting angle at 0°.
Tilt your saw forward so that it rests on the front edge
of the base and blade will not come in contact with the
workpiece when the saw is turned on.
