![background image](http://html1.mh-extra.com/html/ryobi/csb141lz/csb141lz_operators-manual_1506420022.webp)
22
23
ADJUSTMENTS
Fig. 27
REMOVE DUST NOZZLE
AND ADAPTOR
SCREW
Fig. 26
Fig. 28
FRONT LASER
ADJUSTING SCREW
LASER BARREL
WARNING:
Before performing any adjustment, remove blade from
saw. Failure to do so could result in possible serious
personal injury.
WARNING:
DO NOT
point the laser at yourself or others. Class IIIa
lasers will burn the retinas and could cause serious injury
to the eyes.
WARNING:
Use of controls or adjustments or performance other
than those specified herein could result in hazardous
radiation exposure.
ADJUSTING THE LASERS
See Figures 26 - 29.
Two adjusting screws move the laser beams laterally from
left to right. The rear laser can be realigned by adjusting the
screw located in the back of the upper blade guard. The
front laser can be realigned by adjusting the screw located
above the front of the upper blade guard.
The laser beams can also be realigned in a rotational
direction by adjusting the laser barrels.
NOTE:
Draw a pencil line on a scrap workpiece parallel to
the long edge of the base as a straight line guide to aid in
the adjusting process.
To adjust the front laser laterally:
n
Remove the blade.
n
Plug in the saw.
n
Turn laser on.
n
Rest the front of the base on scrap workpiece.
n
Adjust screw as necessary.
n
Since blade thicknesses vary, always make a trial cut in
scrap workpiece to ensure an accurate cut.
n
Check for proper alignment.
n
Repeat as necessary until laser is aligned.
To adjust the rear laser laterally:
n
Remove the blade, dust nozzle, and dust nozzle adaptor
if installed.
n
Plug in the saw.
n
Turn laser on.
n
Rest the back of the base on scrap workpiece.
n
Adjust screw as necessary.
n
Since blade thicknesses vary, always make a trial cut in
scrap workpiece to ensure an accurate cut.
n
Check for proper alignment.
n
Repeat as necessary until laser is aligned.