11
pack.
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Ryobi
Authorised Service Centre for checking or replacing.
NOTE:
This situation only occurs when continuous use of
the tool causes the batteries to become hot. It does not
occur under normal circumstances. Refer to
“CHARGING
A COOL BATTERY PACK”
for normal recharging of
batteries. If the charger does not charge your battery pack
under normal circumstances, return both the battery pack
and charger to your nearest Ryobi Authorised Service
Centre for electrical check.
INSTALLING THE BATTERY PACK
See Figure 2.
WARNING:
Always be sure the switch is in the OFF (O) position before
installing the battery pack. Failure to do so could cause
accidental starting, leading to serious personal injury.
NOTE:
The battery pack is shipped in a low charge
condition. Therefore, it must be charged prior to use.
Refer to page 10,
“CHARGING THE BATTERY PACK”
for
charging instructions.
n
Place the battery pack in the sander. Align the raised rib
on the battery pack with the groove inside the sander,
then slide the battery pack into the sander.
n
Make sure the latches on each side of your battery pack
snap into place and the battery pack is secured in the
sander before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised
rib on battery pack aligns with the bottom of the sander
and latches into place properly. Improper installation of
the battery pack can cause damage to internal compo-
nents.
REMOVING THE BATTERY PACK
See Figure 4.
n
Locate the latches on the side of the battery pack and
depress them to release the battery pack from the
sander.
n
Remove battery pack from the sander.
OPERATION
Fig. 3
CHARGER
ACR1800
BATTERY PACK
Fig. 2
CHARGER
ACR1800
GREEN
LIGHT
YELLOW
LIGHT
RED LIGHT
DEPRESS LATCHES TO
RELEASE BATTERY PACK
BATTERY PACK
LATCHES
BATTERY PACK SHOWN IN CHARGER
Summary of Contents for CCC180L
Page 16: ...16...
