Ryobi AJP-1280, Owner'S Operating Manual

Page: 9 / 16

ASSEMBLY
ATTACHING THE CABLE HOLDER
Slide the opening of the plastic cable holder
bracket into the moulded opening on the
rear of the pressure washer, Fig.4. Using a
screwdriver fasten in place with the 4 connecting
screws in the positions shown in Fig.5. Ensure the
connecting screws are securely tightened.
FITTING THE SPRAY LANCE
Before using the washer fit the spray lance to the
trigger gun.
Fit the spray lance into the trigger gun by inserting
the spray lance section bayonet connector into the
trigger gun bayonet socket by inserting, rotating
and then releasing so the bayonet fitting is locked
in the groove of the bayonet socket, Fig.6.
FITTING THE ADJUSTABLE FAN NOZZLE
Before using the washer fit the adjustable fan
nozzle to the spray lance.
Push the adjustable fan nozzle into the end of the
spray lance. An audible click will be heard when it
locks into place, Fig.7.
To remove the adjustable fan nozzle pull the
locking cap, Fig.7 (7.1), back towards the trigger
gun and remove the nozzle by pulling it forwards.
FITTING THE HIGH PRESSURE HOSE TO THE
PRESSURE WASHER
Remove the plastic cap from the high pressure
outlet.
Carefully cut and remove the cable ties from
around the high pressure hose and unwind, making
sure not to damage the hose surface.
Attach the high pressure hose connector to the
high pressure outlet on the pressure washer, Fig.8.
Screw the fittings together until tight.
Fig. 4
Fig. 5
8
Fig. 6
Fig. 7
7.1
Fig. 8