4.3
Changing Engine Oil
Place the engine on a level surface and place a suitable container under the drain plug bolt
1.
Remove the oil filler cap
2.
Remove drain plug bolt and drain plug washer
3.
Drain the oil into a suitable container.
Please dispose of used oil in a manner that is compatible with the environment. We suggest you take used oil
in a sealed container to your local recycling center or service station for reclamation. Do not throw it in the
trash, pour it on the ground, or pour it down a drain.
4.
Install the drain plug bolt with a new drain plug washer and tighten it to the specified torque.
5.
Add the specified amount of recommended oil into the engine.
a.
Honda GX160: 0.58 Liter (0.61 US qt, 0.51 Imp qt). SAE 10W - 30 is recommended for general use.
b.
Launtop LT210: 0.6 Liter (0.63 US qt, 0.52 Imp qt). SAE I5W-40 mineral oil is recommended for general
use.
*Do not add commercial additives to the oil*
*Do not mix gasoline into the oil*
6.
After adding the oil, check the oil level on the dip stick.
7.
Install and tighten the oil filler cap securely
8.
Make sure there are no oil leaks.
4.4
Winterize Spray System
Drain & clean the tank, hoses and pump:
1.
Connect the spray system intake to a clean water source. (ie: a barrel or tote with clean water)
2.
Run the pump in re-circulate mode until all sealant is expelled from the recirculate hoses
3.
Run the pump in spay mode and spray into your main tank until all sealant is expelled from the spray
hoses
4.
Connect the recirculate hoses to your clean water source from step 1
5.
Run the system for a few minutes in recirculate mode to clean out as much residual sealant from the
recirculate hoses as possible
6.
Run the system in spray mode, and spray into your clean water source from step 1 for a few minutes to
remove as much residual sealant from the spray hoses as possible.
7.
Stop the engine
8.
Disconnect and drain all your hoses, and spray wand.
9.
Remove the drain plug from your pump and ensure that all water has been emptied
10.
Replace drain plug
11.
Drain any remaining sealant in your tank into a smaller container
12.
Power wash both the inside and outside of the bulk tank.
13.
Drain the tank
14.
Remove spray tip from spray wand
15.
Submerge spray tip(s) and the quick connect end of the spray wand in soapy water for several minutes.
16.
Clean the tips and quick connect fitting with a
NYLON
bristle brush (not brass or other metal brush)
Perform an oil change (see section 4.3)
Summary of Contents for RA-SSY-0002
Page 2: ......
