/TLM-TEX & RDMODGSM-TEX
8 / 18
User Manual
Rev. 1.2 - 18/04/08
Fig.2.2: How to extract a SIM card from an Internal Modem
4) Insert the SIM card into the card holder. Make sure the cut-off corner of the
card is in the correct position so the SIM card will lock into place inside the
card holder and its golden contacts will be facing in the correct direction when
the SIM card slides into place in the equipment.
5) Insert the SIM card into the modem accommodated inside the
/RDMODGSM-
TEX
option.
6) Refit the top cover and tighten all screws you had removed previously.
7) Connect a DB9 cable across the “RS232” connector on the front panel of the
external telemetry option and the PC.
8) Connect the GSM modem antenna to the N-type connector “GSM ANT” on the
rear panel of the
/RDMODGSM-TEX
option. Use a broadband Yagi log-periodic
directional antenna (700- 900 MHz).
9) Connect a DB15 cable across the “PTX-LCD REMOTE” connector on the rear
panel of the external telemetry option and the “REMOTE” connector on the
rear panel of the exciter.
10) Connect mains power supply to the VDE connector on the rear panel of the
external telemetry option to power on the telemetry option.
11) Programme the internal EEPROM using the “TELECON” software.
2.3 Remote alarm reporting configuration
Firstly, you will have to set certain parameters in the (internal or external) telemetry
option using the “TELECON” software. Connect the PC serial port COM to the
RS232 connector on the rear panel of the
/TLM
option or the RS232 connector
on the front panel of the
RDMODGSM-TEX
option using a standard Male DB9
- Female DB9 serial cable.
