RVE MK68000, Instruction Manual, Page: 15 / 37

-14-
Step 2-6
2-7
No.
1
2
3
4
5
6
7
Qty Parts Description
零件名称
2-6 2-7主传动系统组装
主轴
尾管
尾传动皮带
杯头内六角螺丝 M3x22
内六角顶丝 M3x3
主轴定位环
M3防松螺帽
尾管
尾传动皮带
杯头内六角螺丝 M3x22
主齿轮组
内六角顶丝 M3x3
2X
主轴定位环
M3防松螺帽
主齿轮安装好以后，需要调整主齿轮与电机齿的间隙。间隙过小会带来较大噪音、震动、还会加速齿轮磨损，间隙过大容易出现扫
齿现象。建议齿轮间隙为0.1-0.2mm。
安装主齿轮组时请先把尾传动皮带套在尾传动大齿轮上。此处需要先把主齿轮与主轴固定好以后，向上提拉主轴，主轴定位环向下压
然后锁紧定位环固定的内六角顶丝。上下移动主轴时应没有间隙。
主轴
Install Main Transmission
Install Main Transmission
主传动系统组裝
Main Shaft
Main Shaft Stopper
Tail Boom
Tail Drive Belt
PA
Set Screw M3x3
Socket Screw M3x22
Nylon Nut M3
When installing the main gear set, first put the tail drive belt on the belt tail drive gear. After fixing the main gear and the main shaft,
pull up the main shaft and the main shaft stopper presses down. Then tight main shaft stopper set screws. There should be no gap
when moving the main shaft up and down.
After the main gear is installed, the gap between the main gear and the motor pinion needs to be adjusted. If the gap is too small,
it will bring greater noise, vibration, and accelerate gear wear. If the gap is too large, it is prone to tooth sweeping. Recommended
gear clearance is 0.1-0.2mm.
1
1
1
1
1
2
1
尾管在5-5零件包内
Tail Boom in the Bag 5-5