ADJUSTING THE HEIGHT OF YOUR MIXING ACCESSORIES
Your mixing accessories are equipped with a system for adjusting their height in
relation to the mixing bowl for optimum results
Press the head release lever to lift the machine head and
insert the creamer-beater, dough hook or whisk.
Hold it in position.
Now lower the head of the appliance by pressing the head
release lever and lower down until a click sound is heard.
This means that the machine head has safely returned to
the correct position.
To adjust the height, use a spanner to loosen the nut
located on the mixing tool. Lift the shaft a little and then
tighten the nut. This will allow you to move your mixing
accessory closer to the bowl bottom.
REMOVING ACCESORIES
Press the accessory up into the mixing accessory drive and turn it clockwise.
Pull it down and out of the mixing accessory drive.
POWER UP
Caution:
- If the speed control is not set to ‘0' (off position), the Pro-Mix will
start when the power supply is connected
- Please fit accessories correctly to avoid damaging the machine.
Check that the speed control is set to "0".
Put the plug into the wall power outlet and switch it on.
SPEED CONTROL
Turn the speed control clockwise to the speed you want.
Turn the speed control back to "0" to turn the motor off.
Turning the speed control anti-clockwise to "P" will give you a pulse at high speed.
Caution: Do not run the motor continuously for more than 10 minutes, it may
overheat. After 10 minutes, switch off for at least 10 minutes to let the motor cool
.
PULSE FUNCTION ("P")
Turning the speed control anti-clockwise to "P" will give you a short burst at high
speed.
Use "P" as a "pulse" function, for greater control over the mixing process.
6
Adjust
here
Summary of Contents for Pro-Mix RHSB032
Page 66: ......
