,
Hold the plastic centre of the chopper in one hand, hold the blade guard in the other, and
pull them gently apart.
8 Use the mixer to mix ingredients together for cakes, sponges, etc.
9 Use the creamer to thicken cream, to beat eggs, and to cream eggs and sugar together.
10 Put the ingredients into the jug – don’t fill it past the 1500ml mark.
11 Replace the lid, and turn it to bring the
d
on the lid over the
L
on the jug, to lock it in place.
12 To add ingredients while the motor is running:
a) lift the pusher out of the tube
b) add the ingredients via the tube
c) replace the pusher
O
WITH THE DISC
13 To fit the slicer or grater to the disc:
a) insert the tab into the centre of the disc
b) lower the slicer/fine grater/coarse grater into the disc
c) secure the latch over the edge of the disc
14 Lower the disc on to the top of the spindle.
15 Replace the lid, and turn it to bring the
d
on the lid over the
L
on the jug, to lock it in place.
16 Remove the pusher, and drop the ingredients down the tube.
17 Replace the pusher, and use it to push the ingredients gently down the tube.
,
Don’t use fingers or cutlery to push food down the tube – only the pusher.
18 Don’t let the jug get more than about half full – stop and empty it.
19 To remove the slicer or grater from the disc, ease the latch away from the side of the disc, and
lift the slicer/fine grater/coarse grater off.
C
POWER UP
20 Check that the speed control is set to 0.
21 Put the plug into the power socket (switch it on, if it’s switchable).
C
SPEED CONTROL
22 Turn the speed control clockwise (1 = low, 2 = high).
23 Turn it back to 0 to turn the motor off.
24 Use low speed (1) for lighter applications, using mainly liquid ingredients, and high speed (2)
for heavier applications, using mainly solid ingredients.
25 Turning it anti-clockwise to
Y
will give you a short burst at high speed, for more precise
control. In this direction, the control is spring-loaded. When you let go, it’ll return to 0.
26 Don’t run the motor for more than 1 minute, it may overheat. After 1 minute, switch off for at
least 2 minutes, to recover.
O
CARE AND MAINTENANCE
27 Switch off (0) and unplug before cleaning.
28 Wipe the outside of the motor unit with a clean damp cloth.
29 Wash the removable parts in warm soapy water, or in a dishwasher
`
.
30 If you use a dishwasher, the harsh environment inside the dishwasher will affect the surface
finishes. The damage should be cosmetic only, and should not affect the operation of the
appliance.
,
Press the chopper into the blade guard before storing the appliance away.
4
