18 Control
settings
Use the Up/Down buttons to select
.
Press the Enter button to store the setting. The display shows
.
Setting output d ensi ty fo r Haze h eads
Use the Menu Previous / Next buttons to select the
option.
Use the Up/Down buttons to select the density from
–
.
Press the Enter button to store the haze setting. The display shows
.
Setting the Timer
Select the TIME option from the RUN menu.
Then set the TRUN and TOFF values from the menu.
The TRUN and TOFF values are set in seconds and are in the range 0-99. The
Fog and Haze values are taken from the menu settings for Fog and Haze. The
timer will cycle continuously until the run menu is changed.
Use this mode for maintaining a low level of fog in smaller venues.
When the timer is running and the display is not showing a menu,
the display shows TRUN or TOFF as the timer cycles between run
and off modes.
Setting the DMX bas e ad dress
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to set the DMX base address from
to
. If
you hold down the button the address will count up or down.
Press the Enter button to store the address setting.
The system will automatically respond to a DMX controller whenever it is
connected.
When using in a DMX system ensure the LINK menu is set to RECV (the default
setting) to avoid causing DMX errors to other devices on the system.
Setting the master -slav e link mod e
It is possible to control several systems from one digital remote. The system with
the remote plugged into it becomes the Master. The other systems are Slaves.
The systems are interconnected with DMX cabling.
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to select
(slave unit) or
(master unit).
Press the Enter button to store the link setting.
The system should be set to
only if it is running as a master. If running as
a slave, stand-alone or DMX controlled it should be set to
. If a system set
to
is connected to an active DMX system, the DMX will be corrupted
causing flickering of lights and other strange symptoms.
Priming th e system after fluid out
If the system runs out of fluid it will automatically shut down and show
on the display to prevent damage to the pump. To suck the new
fluid back into the system and reset the FLU OUT error, replace/refill the fluid
tank and use the prime function.
