Ruris DAC 6000K, Manual

Page: 87 / 128

EN
15
- To check the oil level use the dipstick, the oil must be at full level.
- Check for oil leaks.
- Add oil to the air filter.
5. Clean the unit of dust and dirt, especially the air filter.
8. RUNNING-IN PERIOD
The tiller should run for 5 hours under light load. After this period, change the oil in both
the transmission and the engine. Then fill the transmission oil sump with RURIS G-Tronic
or an oil of API classification GL-4 or higher and the engine oil sump with RURIS 4T-MAX
or an oil of API classification CI-4/SL or higher.
Unleaded gasoline will be used in the tiller.
It is recommended that before use the gasoline is decanted and filtered through a metal
sieve.
9. COMMISSIONING
It is forbidden to idle the engine without load for more than 5 minutes as you risk
damaging the drive belts.
The engine fitted to your tiller is factory run-in and does not require idling.
Before starting up the tiller, you must ensure that the following conditions are met:
▪
fill the air filter container with clean engine oil to the maximum level indicated
▪
there are no persons or objects within a radius of 5 metres on either side of the
tiller with which it could come into contact
▪ the tiller is placed horizontally
▪ the front wheel is mounted and raised off the ground