RUNLUCKY SHOWER SOFTENER
6
3
Cut-off
Filter Valve
Optional
4
1/2
〃
Elbow Connector
The following installation steps for installing before water heater
2.3.2.1.Install the cold and hot connector
a.Shut off the source inlet water, remove the water mixing valve with a spanner, keep the original center
distance of eccentric connector the same, as shown in Figure 10.
b.Take out the hot water connector, cold water connector and 3/4
〃
washers. As shown in Figure 11 to
assemble the cold water connector and hot water connector on the eccentric connectors on the wall.
Make sure the washers no damaged.
c.Use spanner, connect the cold water side of water mixing valve with the cold water connector, connect
the hot water side of water mixing valve with the hot water connector. Make sure the washers no
damaged, as shown in Figure 12.
d.Figure 13 is the schematic view of after water mixing valve installed. According to the view and mark
on connector, adjust the outlet of cold water connector adown, as shown in Figure 13.
e.In order to prevent the big grain substance entering into softener which will affect the effectiveness, it is
suggested to install a shut-off filter valve. Take out shut-off filter valve and washer, tighten it between cold
water and raw water. Place the washer as shown in Figure 14. After installation as shown in Figure 15.
2.3.2.2.Pipeline Installation Instruction
a.Install the 1/2
〃
animated elbow connector on rear outlet behind the shower softener. Disassemble the
sealing plug on rear outlet behind the shower softener as shown in Figure 16, take out the 1/2
〃
animated elbow connector from the accessories bag, tighten it on rear outlet as shown in Figure 17.
Place the washer, schematic view of after installation as shown in Figure 18.
b.Choose the appropriate location to hang the shower softener on the wall.(Please refer the previous
product installation instructions)
