Runco VIDEOXTREME VX-8D, Installation & Operation Manual

Page: 87 / 108

Runco VX-8d Installation/Operation Manual 71
PRE
L
IMINAR
Y
5.1
Lamp Replacement The lamp should be replaced when it reaches the end of its life (typically 2000 hours), or
sooner if a noticeable degradation in brightness occurs. Contact your Runco dealer to
obtain a replacement lamp.
1. Turn off the projector and unplug the power cord. Allow the projector to cool down for
approximately 45 minutes prior to removing the lamp assembly for replacement.
2. Loosen the two rear Lamp Cover
screws and remove the cover.
3. Remove the two lamp assembly
mounting screws.
4. Grasp the lamp assembly handle and pull gently, removing the lamp module from the
projector housing.
5. Install the new lamp module.
6. Replace the lamp cover and re-tighten all screws.
7. Reset the Lamp Hour counter. To do this, select Lamp Hours Reset from the Display
Device - Configure menu. A confirmation dialog box appears. Select “Yes,” then press
ENTER to continue with the reset or “No” to cancel the operation.
5. Maintenance and Trouble s hooting
REMOVE THESE SCREWS