Operation
PlasmaWall XP Series Owner’s Operating Manual
45
PRE
L
IMINAR
Y
I
S
F Night - Input Color:
The Input Color controls are similar to those in the Display Color
menu (see above), but adjust the color balance at the DHD Controller (as opposed to the
display device). These settings are also saved independently for each input.
•
G
ain/Off
s
et:
These controls operate similarly to those in the
ISF Night - Display
Color
menu (see above), but affect the Y, Pb and Pr signal components rather than the
red and blue channels.
• Chroma Delay:
use the Chroma Delay control to correct a mis-aligned image from a
Composite, S-Video or Component video source. Chroma delay in an image causes
color shifts to occur to the left of the vertical edge transitions, producing artificial
shadows or a “halo” effect. If necessary, adjust this setting to eliminate them.
• Pha
s
e:
Adjust the phase if the image (usually from an RGB source) shows shimmer or
“noise.” Pixel phase adjusts the phase of the pixel sampling clock relative to the
incoming signal. The effect of this control is similar to that of a tracking control on a
VCR.
For best results, use a good test pattern such as a smooth gray consisting of a clear
pattern of black and white pixels, or a similar “half on, half off” graphic image. (You may
notice that you can stabilize the image at more than one point. Use either setting in this
case.)
• Noi
s
e Filter:
To apply noise filtering to the input signal, select Noise Filter from the
Input Color menu. The Noise Filter is useful for clearing up noisy images from 480i
video sources.
Use the left- or right-arrow buttons to select the desired amount of noise reduction,
keeping in mind that higher settings (which reduce high frequencies) may also “soften”
the image.
I
S
F Day - Di
s
play Color:
Refer to
ISF Night - Display Color
.
I
S
F Day - Input Image:
Refer to
ISF Night - Input Image
.
I
S
F Day - Input Color:
Refer to
ISF Night - Input Color
.
S
ave I
S
F
S
etting
s
:
Whenever you make a change to the ISF settings, you should always
save it. Select Save ISF Settings from the ISF Calibration menu to do this. In the event you
ever have to perform a System Reset, you can restore the saved ISF settings by selecting
Restore Saved Settings in the Service menu. (System Reset and Restore Saved Settings
are described on page 50.)
Output
S
hift:
The controls in the Output Shift menu are similar to those in the Input
Position menu, except that they change the characteristics of the output signal. These
settings are saved independently
for each a
s
pect ratio
.
S
pla
s
h Configure:
Use the Splash Configure menu to customize the appearance of the
start-up message that appears on the vacuum fluorescent display upon power-up.
• Owner Name/I
S
F Calibrated/I
S
F Other:
You can have the PlasmaWall display the
owner’s name, your name, the phrase “ISF Calibrated” and/or any other string, up to
20 characters in length.
Use the up or down cursor button to select a character. Use the right and left cursor
buttons to change the cursor position. Press
MENU
when you have finished entering
text. Then, check the “Splash Enable” box to have the PlasmaWall display the
information you enter here when it is turned on.