Runco High Definition, Owner'S Operating Manual, Page: 36 / 82

Installation
24 PlasmaWall XP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Digital Video Connection: The PlasmaWall has a dual HDMI input board, labeled HDMI
( S LOT 2) . Connect the HDMI output from the DHD Controller to input “A” on this board,
using an HDMI-to-HDMI cable.
Some PlasmaWall XP Series models have a DVI input board (labeled DVI-D IN ( S LOT 2) )
in place of the dual HDMI input board. Connect the HDMI output from the DHD Controller
to this input, using a DVI-to-HDMI cable or equivalent cable/adapter combination.
R S -232 Connection: Connect the RS-232 output from the DHD Controller to the
S ERIAL input on the PlasmaWall. Use a standard, modular telephone cable with RJ11
plugs at both ends. On the PlasmaWall end, use the provided RJ11-to-DB9 adapter. This
adapter is wired as shown in Figure 3-6.
Figure 3-6. R S -232 Connection from the DHD Controller to the Pla s maWall
3
4
2, 5
XMT DATA RC V DATA
REQUEST TO SEND
SIG GND
3
2
8
7
5
RC V DATA XMT DATA
CLEAR TO SEND
NO CONNECTION
1, 6 1, 9
SIG GND
To/From
DHD
Controller
PlasmaWall
RJ-11 Male
DB-9 Female
1 5
6 9
SERIAL