Crystal Series LCD Installation/Operation Manual
17
PRE
L
IMINAR
Y
3.1
Remote Control
Battery Installation
To install batteries in the remote control:
1.
Slide the battery cover in the direction of the arrow and remove it.
2.
Insert the included batteries. Ensure that the polarities correctly match the
and
markings inside the battery compartment.
3.
Slide the battery cover back on until it snaps into place.
Notes on Remote Control
Operation
• Do not drop the remote control or expose it to moisture or high temperature.
• The remote control may malfunction under a fluorescent lamp. If that occurs, move the
LCD display away from the fluorescent lamp.
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the LCD display.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• Ambient conditions may possibly impede the operation of the remote control. If this
happens, point the remote control at the LCD display and repeat the operation.
3. Installation
1. Do not mix an old battery with a new one or different types of
batteries.
2. If you will not use the remote control for a long time, remove the
batteries to avoid damage from battery leakage.
Note
The signal from the remote control can be reflected by walls or
other surfaces.
Note
Summary of Contents for Crystal CX-42HD
