Runco Crystal CX-42HD, Installation & Operation Manual, Page: 41 / 84

Crystal Series LCD Installation/Operation Manual 27
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Plug the female end of the supplied power cord into the AC receptacle on the side of
the Crystal Series LCD (AC 100V ~ 240V). See Figure 2-2 (CX-42HD/CX-OPAL42),
Figure 2-3 (CX-47HD/CX-OPAL47), Figure 2-4 (CX-55HD/CX-OPAL55) or Figure 2-5
(CX-65HD).
3. Connect the other end to your AC power source.
4. Turn on the main power switch at the side of the display. The power indicator lights
orange to indicate that the Crystal Series LCD is in “standby” mode.
5. Press the ON button ( ) on the remote
control to turn on the display (or press the
power button (
) on the side of the display).
The power indicator turns off.
6. After a brief warm-up period (approximately 10
seconds), the Crystal Series LCD will display
an image.
4.2
Changing the OSD
Language The Crystal Series LCD OSD language is initially set to English, but can also display the
menus in French, Spanish, Portuguese or German. To change the OSD language:
1. Press MENU .
2. Select Setup from the Main Menu.
3. Select OSD Language from the Setup Menu.
4. Press or to highlight the desired language and press ENTER . The change takes
effect immediately.
4. Operation
RGB
HDMI 1 HDMI 2 HDMI 3 HDMI 4
COMP 1 COMP 2 VID 1 VID 2