paste the Ethernet port arrester to the switch framework. The paste location for the Ethernet port arrester shall be
as close to the grounding terminal of the switch.
2)
Based on the distance of the switch grounding terminal, cut the grounding line for the Ethernet port arrester and
firmly tighten the grounding line to the grounding terminal of the switch.
3)
Use the multimeter to check whether the grounding line for the arrester is in good contact with the switch
grounding terminal and the framework.
4)
According to the description on the Ethernet Port Arrester Hardware Installation Guide, connect the arrester using
the adapter cable(note that the external network cable is connected to the end of IN, while the adapter cable
connected to the switch is connected to the end of OUT) and observe whether the LED on the borad is normal or
not.
5)
Use the nylon button to bundle the power cables.
Figure C-2 Schematic Diagram for the Ethernet port Arrester Installation
The Ethernet port arrester is only for the 10M/100M copper Ethernet ports with the RJ-45 connector;
The Ethernet port arrester is not provided, the user can purchase them to address their own pratical requirements. For
the detailed information during the arrester installation, please refer to Ethenet Port Arrester Hardware Installation
Guide, which contains the technical specification and the maintenance and installation of the arrester.
You may pay attention to the following conditions during the actual installation to avoid influencing the performance
of the Ethernet port arrester:
Rever
sed direction of the arrester installation. You shall connect the external network cable to the “IN” end and
connect the switch Ethernet port to the “OUT” end.
