Installing the AP
Follow the steps below:
1)
Drill four 5 mm holes on the wall at the four corners of a rectangle (120 mm x 275 mm).
2)
Insert the anchors into the holes. The rim of the anchor should be flush with the wall.
3)
Drive screws through the mounting bracket into the anchors and mount the AP on the wall or ceiling.
Figure 3-3
4)
Attach the three holes on the rear of the AP onto the three studs on the bracket, and pull the AP 8 mm away from the
screw direction (See Figure 3-3).
5)
Tighten the screw on the bracket until it reaches the hole on the side of the AP.
The depth of the holes must fit the size of the wall anchors and screws used. Make sure that the wall anchors
can be inserted into the holes, leaving the rim of the anchor outside the wall. As you drive the screws in, the
anchors will expand to grip the wall tightly.
When installing the AP on a vertical surface, orient the mounting bracket with the screw side facing down.
