RDV3040-PCIVisionCut operation manual V1.0
SHENZHEN RUIDA TECHNOLOGY
7
installed correctly. If there are fault during opening the VisionCut software, The PCI driver is
installed unsuccessfully.
Step 5
：
connect X
、
Y axis motor
There are 4 channels for motor control. This interface is DB25. The signals in the interface include
pulse+dir, alarm ,servo on and encoder signals. Figure 3 is the definition of the signals.
The step or servo motor signals are in Differential style. Shown in the picture 2-3. Alarm signal is
photoelectric isolation. The connection between RDC3020G and motors is described in detail in
appendix 1.
Motor control signals output
Picture 2-3 pulse+dir Differential output
Picture 2-4 Alarm signal input
Picture 2-5 Servo on and Reset signal output
