37
Deploying the Access Point
Step 2: Complete the Power Connections
Figure 22.
AC connector assembly
NOTE:
Two different-sized grommets are supplied in the AC connector assembly kit. Use
the grommet that is appropriate to the diameter of the AC cable that you are using.
8.
Mate the boot with the cable gland, and then tighten to seal.
9.
Connect the AC cord connector that you have assembled to the AC power socket on
the AP.
WARNING:
Do not apply power to the AP at this point. You should connect the AP to a
power source only after you finish connecting all other components in
“Step 3: Connect
the Access Point to the Network”
on
page 38
.
You have completed setting up the AC power connection.
Use Power Over Ethernet
1.
Obtain a Ruckus Wireless 60W PoE injector (not supplied, part number 902-0180-XX00
where XX is the country code), which may be ordered separately.
2.
Obtain one outdoor-rated Cat5e Ethernet cable and one indoor-rated Cat5e cable.
3.
Connect one end of the
outdoor-rated
Ethernet cable to the
PoE IN
port on the AP,
and then connect the other end to the Data Out/Power Out port on the PoE injector.
4.
Connect one end of the other Ethernet cable to the Data In port on the PoE injector,
and then connect the other end to your network.
5.
Connect the PoE injector to a power source.
