24
Configuring the Access Point
Configuring for Standalone Operation or for Management by FlexMaster
NOTE:
Two different-sized grommets are supplied in the AC connector assembly kit. Use
the grommet that is appropriate to the diameter of the AC cable that you are using.
8.
Mate the boot with the cable gland, and then tighten to seal.
9.
Connect the AC cord connector that you have assembled to the AC power socket on
the AP.
10.
Connect the AC cord to an AC power source.
You have completed connecting the AP to the administrative computer and to an AC
power source.
Use Power Over Ethernet
1.
Obtain a Ruckus Wireless 60W PoE injector (not supplied, part number 902-0180-XX00
where XX is the country code), which may be ordered separately.
2.
Obtain two Cat5e or better Ethernet cables.
3.
Connect one end of one Ethernet cable to the Data Out/Power Out port on the PoE
injector, and then connect the other end to the
PoE IN
port on the AP.
4.
Connect one end of the other Ethernet cable to the Data In port on the PoE injector,
and then connect the other end to the admin computer.
5.
Connect the PoE injector to a power source.
6.
Check the
Power LED
on the side of the AP. Initially, the LED will turn
red
as the AP
powers on. After it completes the power-on sequence, the LED will turn
green
.
You have completed connecting the AP to the administrative computer and to a PoE power
source.