Q910-US00 LTE Access Point Quick Setup Guide
Q910-US00 User Guide
Part Number: P01-Q910-US00
22
Step 9: Installing the Security Cable
1.
Thread the security cable through the mounting bracket and through the eye on the cable itself.
2.
Attach the safety cable to the AP.
FIGURE 11 Attaching the Security Cable
Congratulations! You have mounted your Q910 access point.
Step 10: Checking LED Lights
Once connected, the AP will power on and automatically connect to the Ruckus Cloud over the Internet to configure
itself. You will see
some activity and after 2-5 minutes all lights should turn solid Green or solid Amber (LTE LED).
If any light on the AP is off or flashing, see the following table for troubleshooting:
TABLE 2 Troubleshooting Table for LED Lights
Light
Troubleshooting Action
PWR
Check Power, Ethernet connections and PoE switch.
EMS
Check Internet connection and network settings.
EPC
Check Internet connection and network settings.
SYNC
Make sure at least one of the APs in the network is near an unobstructed window for a good GPS signal.
LTE
Use the Ruckus Cloud.
Factory Resetting AP Q910
In case the AP fails to connect to the Cloud, do Factory Reset for the AP by long-press-hold action for up to 20 seconds on to the Reset
button provided right beside the GPS connector.
(Once connected to the Cloud, Factory Reset can be performed via Edit AP drop-down as well).