Q910-US00 User Guide
Part Number: P01-Q910-US00
12
Physical Installation of Q910 LTE Access
Point Mounting Instructions
•
One ground wire with lug
•
Service Level Agreement/Limited Warranty Statement
•
Regulatory Statement
•
Quick Setup guide
Mounting Instructions
The following section provides instructions for connecting, attaching, and mounting the LTE Access Point.
Step 1: Connecting and Sealing the RJ45 Cables
Q910 may use one or two RJ-45 cables, one for Ethernet and Power (PoE IN), and another when Q910 is optionally supplying Ethernet
out to a peripheral device, such as a small camera or backhaul radio. Connect and seal the RJ-45 cables using the M25 data cable
glands.
WARNING
Do not use any PoE Injector that is not tested and approved by Ruckus Wireless to power the Q910 Access Point.
WARNING
Do not plug PoE IN power into the Ethernet OUT port.
WARNING
If using a PoE switch to supply power to Q910, 30W must be reserved for Q910 on the switch. Failure to ensure a 30W
supply may result in unpredictable operation of the access point.