Ruckus Wireless MediaFlex 7811 Access Point
57
Verifying Proper Provisioning
Figure 38—LEDs
13.
Make sure you are using the power adapter supplied by Ruckus Wireless.
14.
Make sure the Power LED is lit. If it is not lit, make sure that the power cord is properly connected to the 7111,
and that the power supply adapter is properly connected to a functioning power outlet. If the error persists,
you have a hardware problem and should contact technical support.
15.
Make sure your Network LED is lit. Make sure that the Ethernet cable connections are secure at the 7111
adapter and your computer. The Network LED on the 7111 adapter indicates link when the adapter is fully
seated in the port.
16.
Make sure the Wireless LED is either steady or flashing Green. If is not lit, the Wireless settings may be
incorrect between the 7111 adapter and the AP.
17.
If you still cannot see the video, proceed to the next section,
”Verifying Proper Provisioning.”
Verifying Proper Provisioning
To verify proper provisioning of the 7111, you can log in to the Web interface of the 7111 using the following
steps.
Manually Configuring an IP Address on Your Computer
Follow the steps detailed in
Configuring an IP Address on Your Computer on page 9
.
Connecting and Configuring Your Ruckus 7111 Adapter
The following steps guide you to set up and gain administrative access to your Ruckus 7111.
1.
Move the 7111 next to your computer.
2.
Connect the AC power adapter to the Ruckus 7111 and plug the other end into either a power outlet or to a
surge protector that is plugged into a power outlet.
Dome
Signal Quality
Wireless Device
Association
Power
WAN
Connectivity
