13
3.
Press the suction motor push button (3); the suction
motor symbol changes from off to on and the motor
starts suck up.
4.
Press the solenoid valve push button (4); the solenoid
valve symbol changes from closed to open.
5.
Lower the brush base onto the floor by pressing the
pedal (5).
6.
Turn on the brush by pressing button (6), on the
display is visualized first the down symbol and then the
one of the brushes motor activation.
7.
Acting upon the squeegee lifting lever (7) lower the
squeegee.
8.
Acting upon the levers drive control (8) the machine
starts to move, the brush starts to rotate and the water
begins to flow automatically.
Releasing the drive control levers will stop the flow.
9.
During the first metres check that the squeegee
adjustment guarantees a perfect drying action and that
the detergent solution flow is appropriate. It has to be
sufficient to wet the floor uniformly avoiding the leakage
of detergent from the splash guards. Always consider that
the correct quantity of solution detergent depends on the
type of floor, dirtiness and machine speed.
Moving the machine backwards, make sure that the squeegee
is lifted.
Working with the manual detergent
solution adjustment
If the manual adjustment
mode is selected (see
chapter (MANUAL
ADJUSTMENT OF THE
DETERGENT SOLUTION
CARRIAGE) the detergent
solution carriage is being
adjusted using the valve lever
MOVEMENT AND SPEED ADJUSTMENT
The traction of the machine is given through an electronically
controlled motor.
To move the machine, act
upon the key (1) and then
rotate the levers drive control
(2) placed on the handle
bar, in forward for the
forward drive, in reverse for
the backward drive. The
control acts in a progressive
way, therefore it is possible
to graduate the speed
depending on each
requirement rotating the levers
whatever it is necessary.
Furthermore it is possible to adjust the maximum speed acting
upon the push button (3) to increase it and on the button
(4) to decrease it.
Every change will be visualized through its symbol on the
display.
During reverse motion the speed is reduced.
Suction motor silent mode
It is possible to start the
silent
mode
of
the
suction motor by pressing
for a few seconds the
switch-on button (1) of
the suction motor.
When the silent mode is on, the symbol on the display
changes.
Working brake
To stop the machine during
normal working situation, it
is sufficient to release the
levers drive control (1), as
the machine is equipped
with an electronic braking
system. The brush and the
detergent
solution
stop
automatically.
Detergent solution reserve signal (H2O on
the display)
When the indication H2O on the display appears, this means
that the detergent is getting low corresponding to 10% of the
maximum capacity of the solution tank.
