9
2.3
Preparing Installation
Before installing OW-2000 for outdoor application or hard-to-reach
location, we recommend configuring and test all the devices first.
For configuring the OW-2000, please follow the quick steps below to
power up the OW-2000. Refer to Figure 2-4 for steps 1 through 5.
Figure 2-4
Step1 : Connect the DC plug of the AC/DC power adapter into the DC
Input Port of Inline Power Injector and the wall-mount plug into a
power outlet or power strip (refer to
page 6
). The Power LED on the
Inline Power Injector will light up.
Step2 : Run the cross-over type uplink Ethernet cable from Data Input
Port (refer to
page 6
) to the Ethernet port on a PC.
Step3 : Connect the 30m CAT 5 Ethernet cable into the OW-2000 unit.
Hand tighten the connector.
Step4 : Connect the remaining end of the 30m CAT 5 cable into the PoE
labeled AP/Bridge. This is the power side of the PoE that will power up
the OW-2000.
When the OW-2000 receives power over the Ethernet cable, the
OW-2000 will start its boot up sequence and the Active LED on the Inline
Power Injector will light up.
You can configure the OW-2000 via HTML browser, such as Microsoft
Internet Explorer or Netscape Navigator from a remote host or PC.
