BTR-30N, TR-30N, TR-32N
Introduction 19
1.
MENU and SET buttons
- Used to select menus and set
options on the LCD.
2.
LCD (Liquid Crystal Display)
3.
UP and DOWN buttons
- Used to select beltpack options
on the LCD.
4.
Programming Connector
- Used to update software in
unit.
5.
Auxiliary Input Audio Jack
- 1/85” (3.5mm) mono input
jack. Local only to beltpack.
6.
Headset Connector
- Male XLR connector or female
XLR. A dynamic or electret headset microphone is
automatically detected by the beltpack and a bias voltage
supplied, if needed. 4-pin RTS units are monaural. 5-pin
RTS units have a software setup to select if XLR pin 3 or 5
is the channel 2 output and if pin 3 is ground.
7.
Battery Latch
- Press down to release the battery pack.
While the latch is held down, slide the battery pack about 1/
8 inch back, toward the latch, until it stops, then lift it out.
8.
Receive Antenna
- Screw type 1/4-wave replaceable
antenna. The color dot on the screw end of the antenna must
match color dot on the antenna receptacle.
9.
Transmit Antenna
- Screw type rubber duck replaceable
antenna. The color bands near the screw end of the antenna
must match color dot on the antenna receptacle.
IMPORTANT:
Microphone gain and transmit mode is
set via software menus.
FIGURE 8.
TR-32N Rear Panel/ Connector/Antennas
FIGURE 9.
Handset Jack Wiring
