BTR-30N, TR-30N, TR-32N
Introduction 15
.
FIGURE 5.
TR-30N Rear Panel/Connector/Antennas
1.
MENU and SET buttons
- Use to select menus and set
options on the LCD.
2.
LCD (Liquid Crystal Display)
3.
UP and DOWN buttons
- Use to select beltpack options
on the LCD.
4.
Programming Connector
- Use to update software in unit.
5.
Headset Connector
- Male XLR or female XLR connector.
A dynamic or electret headset microphone is automatically
detected by the beltpack and a bias voltage supplied, if
needed.
6.
Battery Latch
- Press down to release the battery pack.
While holding the latch down, slide the battery pack about
1/8 inch back toward the latch until it stops, then lift it out.
7.
Receive Antenna
- Screw type 1/4-wave replaceable
antenna. The color dot on the screw end of the antenna must
match color dot on the antenna receptacle.
8.
Transmit Antenna
- Screw type rubber duck replaceable
antenna. Color bands near the screw end of the antenna
must match color dot on antenna receptacle.
FIGURE 6.
Headset Jack Wiring
IMPORTANT:
Microphone gain and transmit mode is
set via software menus.
