RTS BP-6000, Technical Manual

Page: 30 / 32

30 Operation and Maintenance Universal Beltpack – BP-6000
3.
Being careful not to pull the connectors from the headers, attach jumpers to J3, J4 and J5 on the
board , as described in Table 3.
IMPORTANT:
If you need to move the connector wires to access the J4 jumper, gently push them to
either side.
4.
Carefully slide the top plate assembly into the beltpack enclosure.
5.
Using the provided screws and O-rings, replace the side screws .
IMPORTANT:
To ensure the beltpack is properly grounded when reassembling, fully tighten the
screws on one side of the unit, and then fully tighten the screws on the other side of the
unit.
TABLE 3.
J4 and J5 Jumpers
Normal Local Power
Pins 1&3 and Pins 2&4
shorted Pins 3&5 and Pins 4&6
shorted
TABLE 4.
J3 Jumpers
Normal Local Power
Pins 1&2 shorted Pins 2&3 shorted