Universal Beltpack – BP-6000
Initial Setup and Configuration 25
Send Mic Kill Menu (Audiocom Mode Only)
The
Send Mic Kill
menu is used to send a shut off signal to a microphone on a beltpack, user station, or
master station that has been left on. A 24 kHz signal is sent to the party-line where the beltpack with the
microphone left on, signalling it to shut off.
Available options are
Yes
or
No
.
IMPORTANT:
The Send Mic Kill signal is not sent until the beltpack has properly exited the
program menu.
To
send a mic kill
, do the following:
1.
While in the program menu, navigate to
Send Mic Kill
.
[voice prompt] “Send Mic Kill”.
2.
Press the
TALK button
.
[voice prompt] “No”.
OR
Press the
TALK button
again.
[voice prompt] “Yes”.
3.
Exit the
Program Menu
(see “Exit Program Menu” on page 19).
LEDs Menu
The
LEDs menu
is used to set the LEDs to normal intensity or dimmed on a beltpack.
Available options are
On
or
DIM.
The default for this menu is
On
.
To
configure LEDs
, do the following:
1.
While in the program menu, navigate to
LEDs
.
[voice prompt] “LEDs”.
2.
Press the
TALK button
.
[voice prompt] “On”.
OR
Press the
TALK button
again.
[voice prompt] “DIM”.
3.
Exit the
Program Menu
.
Summary of Contents for BP-6000
