Advanced Control Processor
XP-8
20
InFrAred reCeIVers
The XP-8 is compatible with industry standard IR receivers, repeater
systems, and keypads. Connect the SIGNAL INPUT, GROUND, and +12VDC
(if power is needed) terminals to the signal out, ground, and power (if
needed) terminals of the desired device.
If the XP-8 sees an incoming system trigger code with a matching zone ID,
it will execute the command or macro associated with that code. The XP-8
can be programmed to either block or pass miscellaneous IR data through
its output ports.
rF reCeIVers
The XP-8 is compatible with RTI RF receiver modules (e.g. RM-433). Up to
10 RM-433 receiver modules can be connected with a maximum total wire
run of 1000 ft. Follow the guide included with the modules for installation
instructions.
InFrAred HIGH Out
The XP-8 is compatible with industry standard IR connecting blocks.
Connect the HIGH OUT and GROUND terminals to the signal input and
ground terminals on the connecting block. This is useful if you have many
devices to control, or you want to extend control into other rooms.
This output has short circuit protection, but does not provide a series
resistor for current limiting. It should not be connected directly to IR
emitters.
CHAPter 4 | COnneCtIOn OPtIOns
Summary of Contents for Under Control XP-8
