3
It’s Under Control
®
or does not need to be charged. A fully discharged battery will take
approximately 2- hours to completely re-charge.
GETTING STARTED
NOTE:
The following steps for initial installation including removing the
battery door should be performed by an authorized service center or
trained installer only.
Start by inserting the battery connector into the mating plug on the T2-B.
Make sure the connector is oriented properly before attempting to insert
it. Next, turn the unit on by sliding the power switch into the “ON” position
(toward the battery).
The T2-B is turned-on by touching any area of the display or any keypad
button. If the tilt sensor is enabled, picking up the unit will also turn it on.
During normal use the T2-B turns-on instantly from its sleep mode.
POWER
SWITCH