![background image](http://html1.mh-extra.com/html/rti/siloking-1500/siloking-1500_instructions-and-operating-manual_1497617008.webp)
- page 8 of 15
–
Inst ruct ion and operat ing manual CVS SiloKing 1500
Pow erband driven
(for-030/031013)
3
Mounting installation
3.1
Mounting instructions RTI installation powerband driven
A
While placing the installation on a pallet, make sure the installation is approximately
30 cm off the ground (raising the installation w ith timber if necessary).
B
Drive the installation up to the desired location next to the truck. Make sure the
angle of the drive shaft is as small as possible.
Please find the maximum mounting
angle in the mounting instructions provided by the truck manufacturer.
Image 3.1.1
C
Place the installation at the same level as the chassis and parallel to the truck.
Measure the PTO-
shaft. Make sure the installation doesn’t exceed the w idth of the
truck.
D
Measure the brackets and try to use all the holes in the chassis. Brackets should be
painted or otherw ise protected against corrosion.
E
The installation must be mounted w ith at least 3 brackets. (With a box or tank
combination at least 4 brackets should be used)
F
Mark w here the holes need to be, drill/punch the holes, paint the brackets in the
colour of your choice and let them dry.
G
Mount the painted brackets onto the chassis w ith the bolts and nuts specified by
the manufacturer.
H
Subsequently mount the installation onto the brackets w ith M14 bolts (8.8),
w ashers, spring w ashers and nuts.
NOTE
With a vacuum installation the vacuum valve must be set to -0.5 bar. Please
note: the vacuum valve should be set w hen testing the installation before initial
operation. The vacuum valve has not been set w hen the installation is delivered
as a building kit (w ithout mounting by RTI).