23
It’s Under Control
®
CHAPTER 3 | INSTALLATION AND OPERATION
Applying Power to the CP-16i Amplifier
CAUTION:
This unit should only have one source of incoming power. Using
more than one source of power to the CP-16i can result in damage to the
internal components and a possible burn out.
CAUTION:
Apply power to the unit only after installation is complete.
AC Power Plug Connector
The following table provides pinout information for the AC Connector:
• Mains Power Fuse - T6.3A H Mains Power Fuse fuse provides over-current
protection.
•
Mains Power Switch - The power switch is the AC mains switch, which turns
everything off when it is in the Off position, and powers everything on
when it is in the On position.
1. Connect a standard IEC 3-pole detachable power cord to the AC Mains
power connector on the rear panel.
2. Plug the attached power plug into a correctly grounded wall outlet.
3.
Switch the Mains Power Switch (on the rear panel) to the On position.
Note that the POWER LED on the front panel lights Green to indicate that the
amplifier is receiving power (and not in Standby mode).
Entering Standby Mode
To put the CP-16i Amplifier in Standby Mode:
•
Remove signal from the signal sense input, or disable signal sense input.
See the Pin 1 - Signal Sense section on page 15 for details.
•
Enable 3-5V trigger -> Disable 3-5V trigger
Note that the POWER LED on the front panel lights Red to indicate that the
amplifier is receiving power, but is in Standby mode. Also note that when in
Standby mode, the 12V output trigger is turned off.
Summary of Contents for Cool Power CP-16i
Page 27: ...27 It s Under Control...
