RSI XL600, Complete Setup And Programming Manual

Page: 11 / 30

2011/11/28 E2.5 Installation Manual for XL600GPRS
11 | P a g e
GPRS LEVEL?
TEST IN PROGRESS
YES = END
GPRS LEVEL
x/5
RECORDING
DEVICES
PRESS PROGRAM
BUTTON OF DEVICE
ENTERING A NEW
DEVICE?
END OF
CONFIGURATION
CLOSE THE PANEL
OPERATION
COMPLETED?

YES

YES

YES
ESC/NO
During the GPRS Level test the Modem will boot and
attempt to gain access to the internet to post a Level out of
5 or an error Code that will help troubleshoot why it cannot
connect. To keep the keypad awake use any keys on the
keypad except the YES, ESC/NO, and CLR keys. This test
can take up to 5 minutes. Once the level or error has
posted press YES to continue in programming.
*For explanation of GPRS errors see bottom of page.
Videofied will require a 3/5 or better for reliable transmission
of Video alarms.
Each device has a unique programming button. Please
reference the Installation Sheet for the device you would like
to program.
Before completing programming make sure that all tampers
are depressed by verifying that each devices indicator LED is
off.
(Device Type) #
Recorded
RADIO RANGE
TEST?
RADIO RANGE
TEST?
RF TEST
x/9

YES

YES
AREA ALLOCATION:
NAME LOCATION:
FUNCTIONAL
DEVICE TEST?
ESC/NO

YES

YES
ESC/NO
Use the arrow keys to select the proper area. Devices that
need an entry/exit delay should be set to AREA 1. Devices
that must be instant trigger should be AREA 2.
The Central Station will see the name of the device when
they receive the alarm. Using the alphanumeric keypad enter
in a discription of the device location and press YES.
Repeat the previous steps for programming additional
devices by hitting YES. Once all devices have been entered
press ESC/NO.
You must allow the Radio Range test to run for at least 30
seconds (9/9) before stopping the test.