2011/11/10 Ed 1.5
Setup and Programming manual for XT series GPRS
10 |
P a g e
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
ENTER THE
INSTALLER CODE
4 TO 6 DIGITS
THEN YES
INSTALLER CODE:
INSTALLER CODE:
xxxx
YES
CONFIRM CODE
RE-ENTER CODE
CONFIRM CODE
xxxx
CODE NAME :
ACCESS 1
ENTRY COMPLETE
RADIO RANGE
TEST ?
RF TEST
x/9
YES
ESC/NO
ADJUSTING
TIME AND DATE
DATE (Year) :
09/ /
DATE (Year) :
10/ /
DATE (Month) :
10/01/
DATE (Month) :
10/11/
YES
YES
Wait while the screen changes
Use the Alphanumeric Keypad to enter the Installer Code
*This code is important to keep track of. There is no back
door to the system
You may name the installer code using the Alphanumeric
Keypad. If you leave the name blank it will default to
‘ACCESS 1’
Use the
or
to set the Year
Use the
or
to set the Month
RADIO RANGE
TEST ?
YES
The Radio Range test should be run during device
recording to ensure proper pairing with the control panel.
This test is the communication strength between the device
and the control panel. The keypad will display a real time
RF level for the device that is being tested. This test will run
until stopped and should be run for at least 30 seconds to
receive accurate results.
The RF level must be 9/9 for reliable transmission.
Wait while the screen changes
From here until the end of initial programming
you will not be able to step back to a previous
parameter. All parameters can be changed after
initial programming has been completed.
