Command
Response
Command
Response
O
Off
T
Tare
M
Displays the Counts
F
Mode
C
Cal
U
Units
P
Percentage
7.0 Communications & Printing
The ES-H, ES-HA balances can be connected to a PC or appropriate printer
using a null modem cable (not supplied). The balance will transmit the gross
or net weight and unit or the number of pieces if you are using the piece
counting function.
Connecting to PC
1. Connect the appropriate cable to the 9 pin D connector on the balance.
2. Connect the other end to an available COM port on your PC.
RS232 Data
Baud Rate = 9600
Data Bits = 8
Balance RS232
connector
Sample PC RS232
connector
Parity = None
Stop Bits = 1
Note:
When connecting to a PC or other device, you must cross the transmit
and receive lines.
3. Start HyperTerminal or similar utility.
The table below shows a list of available commands and their responses.
Note:
All commands are capital letters. There is no carriage return after the
command.
Table 1: Available Serial Commands
Summary of Contents for ES-1000H
Page 1: ......
