aRp-7010, aRp-7013, aRp-7013H
13
tRoubleSHootInG
troubles
possible causes
Air Conditioner does not operate
- Check and reset the power plug. Wait 3 minutes and try to run the unit again.
- The batteries in the remote may need to be replaced. Replace the batteries and try to run the unit again.
- Make sure the plug is properly plugged into the outlet.
- The set temperature may be too close to room temperature. Lower the set temperature.
- The air outlet may be blocked. Check the air outlet and remove any items that may be found.
Air Conditioner runs but does not cool
- Check the room for open doors or windows and close them.
- There may be another appliance in the room giving off heat. Check the room and turn off the appliance.
- The air filter may be dirty. Check the filter and clean if necessary.
-∙The∙air∙exhaust∙or∙intake∙may∙be∙blocked.
- The set temperature may be too high. Check the set temperature and reduce it if necessary.
Water Full indicator is lit up
- Unit needs to be drained. Follow draining instructions on page 11.
Water is leaking from the unit
- Make sure unit is on a flat surface
- Drain the unit.
Machine automatically turns off
- Timer may have been set to shut off. Turn power back on.
LED displays shows E0
- Room temperature sensor error
LED display shows E1
- Evaporator sensor error
LED display shows E2
- Water pump error
LED display shows E3
- Condenser sensor error
