aRp-7010, aRp-7013, aRp-7013H
7
opeRatIon
before use
•∙Check∙to∙make∙sure∙rubber∙drain∙plug∙is∙securely∙plugged∙into∙the∙drain∙port∙on∙the∙back∙of∙the∙unit∙to∙prevent∙water∙leaks
•∙Check∙to∙make∙sure∙that∙air∙conditioner∙has∙been∙properly∙vented∙out∙the∙window∙(∙See∙Installation∙pg∙6.)
•∙Check∙to∙make∙sure∙air∙conditioner∙is∙on∙a∙flat∙surface
•∙∙Push∙down∙on∙the∙back∙of∙the∙louver∙located∙on∙the∙top∙of∙the∙unit.∙∙The∙louver∙will∙snap∙into∙open∙position.∙∙To∙close∙while∙unit∙is∙not∙in∙use,∙simply∙press∙back∙down.∙∙
Do not run the air conditioner with the louver closed. This may damage the air conditioner.
•∙Conduct∙a∙Power∙Plug∙Check:
1. Press the RESET button on the power cord.
2. Plug cord into an electrical outlet.
3. Press the TEST button on the power cord. The RESET button should pop up.
4. Press the RESET button for use.
5. Do not use the air conditioner if the test fails.
note:
If you turn the air conditioner off and immediately restart it, allow 3 minutes for the compressor to restart cooling. In the event of a power failure, wait 3 minutes
before restarting unit.
control panel
ON / Off button
Timer set control
Temperature set
control
Remote control receiver
Display
Water Full light
Fan speed control
Mode control
