Roxell Titan, User Manual

Page: 11 / 18

ROXELL - 0819
Titan-
User's guide -
EU
8
TROUBLE SHOOTING GUIDE
Switch off the main switch first.
Use personal protective equipment.
Up to 300 kg/line!
DANGER
ACTIONS IN GREY BACKGROUND MUST BE DONE BY A TECHNICALLY TRAINED PERSON.
PROBLEM CAUSE CORRECTIVE ACTION
None of the feeder
lines run.
No current. Replace defective fuses or reset circuit breakers.
Check current supply to the house.
Defective time clock. Replace defective clock.
Time clock not properly set. Readjust tabs.
One/more lines do
not run.
Pans are empty
Wires from motor damaged. Measure current in motor wires. Replace wires if
defective.
Motor protection switched off. Reset motor overload button.
Defective sensor in the control unit, or
sensor not properly adjusted.
Check the good operation of the sensor.
Replace if necessary.
Control unit not functioning properly. Install the optional LED light kit.
Check temperature. Control unit must be the most
attractive one, especially the control unit of
the feeder line below the Flex-Auger control unit.
Defective sensor/minimum switch
control unit or 100 kg hopper.
Check control unit sensor or switch. Replace if
necessary.
Motor is often
overloaded.
Oil on auger overloads the motor. Clean the auger by running repeatedly 25 kg of
feed through the line.
Not enough current supply to the
motors.
Check current supply at motor location. Start the
motor. Measure start current on motors. Wiring
must be thick enough to guarantee good operation
of the system.
Object blocks the auger. Motor runs,
then stalls. Feed sticks to the tubes.
Check if there are no objects in the boot, the control
unit and the drop holes of the feeder pans. Remove
any objects.
Auger stalls.
Anchor bearing worn out or broken.
Replace bearing. Gently slide auger back into
the tubes. Don't let it jump back: your finger or
the bearing could be damaged .
Auger not enough stretched. Shorten the auger.
Object blocks the auger. Remove the object.
Tubes / boot wear
rapidly, much noise
when system runs.
Auger kinked or bent at the wear
point.
Auger end overlaps the anchor end.
Make sure not to kink the auger when using
gripping pliers. Auger must not overlap the anchor
end.
Not enough feed
supplied to fill up the
lines.
Flex-Auger drop holes are too small
or point upwards.
Make holes wider/turn tubes with holes
downwards.
Flow regulator in boot of feed supply
system blocks passage of the feed.
Adjust flow regulator to get a higher capacity.
Flex-Auger capacity is too low. Check the capacity of the Flex-Auger according the
specifications.
Check the installation of the Flex-Auger.
Not enough time set on the time clock. Extend operation time per meal.
Feed drops directly
on the adjuster ring
of the grill.
Pan not installed over the hole. Remove the top support. Install the pan ass'y over
the hole and the lips.