IMPORTANT NOTE
To VALIDATE the guarantee, this item should be erected on
50mm x 50mm treated wooden or similar bearers (These are
not supplied with the kit.) Ground contact must be avoided.
1. Floor
Position the door end floor blocks flush to the edge of the floor between the floor frames. Secure each block in place using 2 x 32mm screws. Screwing through the floor
board into the block. Prepare a level area for the building sit. Place the floor in position and ensure level.
Drill
3mm
It is recommended to drill pilot holes for
each screw before assembly.
Plain Side Panel
Plain Side Panel
Important
Use this diagram to check the
correct orientation of the corners
Hatch Panel
Hatch Panel
Door end
Back P
anel
Back Panel
Side Panel
Panel frames rest on
the floor
2. Wall panels
Position a plain side panel and the back panel on the floor as shown. Note how the panel frames sit on the floor with the panel cladding overhanging the floor edge. Ensure
square and secure using 4 x 50mm screws. Screw through the frame of the side panel into the frame of the back panel. Continue to add the remaining panels in the same
way, as shown below.
3. Top panels
Position a back wall top panel on top of the back wall and secure using 3 x 50mm screws. Screw up through the top frame of the back panel into the bottom frame of the
top panel. Attach a top a wall panel to the door end in the same way using 2 x 50mm screws. Add the plain side top panel and secure to the wall using 3 x 50mm screws,
then add the hatch side top panel using 3 x 50mm screws. In each corner use 2 x 50mm screws to join the four top panels together. Screw through the plain side and hatch
side top panels into the door and back wall top panels.
Drill
3mm
It is recommended
to drill pilot holes
for each screw
before assembly.
Panel cladding
overhang floor edge
Drill
3mm
It is recommended to drill pilot holes for
each screw before assembly.
Important
It is possible to build this
product with the hatch
panesl on the other side of
the building.
32mm
50mm
50mm
50mm
50mm
50mm
50mm
50mm
50mm
50mm
