Document 80-0002, Rev. X6
27
9.3
A
RMRESTS
The armrests can be flipped up and swung
back for easier transfer in and out of the
wheelchair.
To flip the armrest up to swing it back:
Pull the locking lever (1) and lift the
armrest.
To close the armrest:
Simply lower it down, until the front tip
slides back into the bracket (2). It will
lock itself automatically.
To remove the armrest:
After flipping the armrest up, pull it
straight upward to disengage from the
chair.
9.4
A
NTI
-T
IPPERS
WARNING! Risk of Serious Injury or Damage
Anti-tippers improve the wheelchair’s rear stability and thus the
user’s safety. They MUST remain attached to the chair at all times.
The Revolution 1.0 is not to be used without them.
Adjusting the anti-tippers
Pull the round disk (1) to the rear to disengage the locking
pin.
Slide the arm (2) downward until the small wheel (3) is
within 1.5” to 2” from contacting the floor. Slightly adjust
the position of the arm until you feel the locking pin engage
and that the arm is no longer free to move.
Repeat for both anti-tippers.
WARNING! Risk of Serious Injury or Damage
You MUST ensure that both anti-tippers are adjusted to the same
height and they MUST be between 1.5” to 2”.
1
2
1
2
3
