Rowe 4900JR SERIES, Field Service Manual

Page: 16 / 26

General Information
This page contains general information on installing,
operating and maintaning the BA**B Series Bill Acceptor.
Taking time to read this information and becoming
familiar with it will help you obtain the best performance
from your BA**B.
The BA**B Series Bill Acceptor is designed to fit into
existing standard openings established by vending
machine manufacturers. These mountings usually consist
of four studs in the vending machine to which the bill
acceptor is mounted. If an additional mounting bracket
and/or hardware is required, please contact your nearest
Coinco office for additional kit information.
NOTE: The BA**B requires one of the following
power harnesses.
#407052-1
(8 Pin Jones Interface)
#407419-1 (4 Pin Interface)
#407420 (Multi Drop Bus Interface)
On most controller-type vending machines, the BA**B
power cable interfaces directly to the vending machine
electronic controller board through an additional
vendor interface harness. Contact your nearest Coinco
office for additional harness information.
Installation and Operation
Before installing the BA**B series bill acceptor into the
vendor, set the BA**B option switches, (if desired settings
are different from those set at the factory.) The BA**B is
currently set to accept one dollar bills only, face up in both
directions. See “BA**B Option Switches: and “Setting
Option Switches” sections for detailed infromation.
BA**B SERIES BILL ACCEPTOR
Installation & Operation Guide
With Multi Drop Bus
Coinco Publication #921223 Rev. 6 5/99
1. Turn OFF vending machine power.
2. Install the BA**B into mounting hole of vending.
3. Connect the BA**B power cable (not included)
between the BA**B control box and the changer/
vending machine.
4. Install a Coinco coin changer or the equivalent into the
vending machine according to the coin changer
instructions.
5. Load the coin changer coin tubes with a minimum of
ten coins in each tube making sure all coins lie flat.
6. Restore power to vending machine (BA**B stacker
will cycle upon power-up).
Figure 2
** = 3 0
3 2
5 0
5 2
7 0
7 2
9 0
9 2
Bill Box Size
Voltage 0=110V
2= 24V
Figure 1