Roverpet
20 Kiji Dava Circle Prescott, Arizona 86301
800-658-5925
4.) Insert the four #34URP uprights into the upward facing holes of the
#24TLC legs in the following manner: the two pipes identified with red
marks on their tops are to go into the lower left and upper right locations
as viewed with one of the long faces of the assembly positioned in front of
you. Turn the upper-most holes in the uprights to face each other across
the longer faces of the assembly as shown in the left photo at the top of
the next page.
5.) Install the corner rings of the fabric cat play center over the uprights, being
sure that the sheepskin fabric is facing up as shown in the above right
photo.
6.) Install the short and long cross bars into the holes in the uprights to mimic
the assembled view that appears in the photo at the top of the previous
page while paying attention that the following assembly criteria are
adhered to:
The bottom rings of the enclosure must rest
under
the first (lowest)
set of long cross bars that span across the wider faces of the tower
The upper set of short bars that spans across the narrower faces of
the tower are to pass
through the support sleeves
in the fabric
enclosure.
The top rings of the cat play center must rest
on top
of the highest
cross bars that span across the wider faces of the tower.
7.) Install the top arms into the open ends of the uprights.
8.) Refer to the instructions included with the Roverpet
#KK3 Cat Climber
to
assemble the 3-level tower and to complete the unit.
To reduce the
squeaking/friction caused by product on product place a thin layer of Vaseline on
the connection points.
Property of Roverpet
Install the uprights with
red marks on their tops at
these two locations and
face the upper-most holes
in the uprights towards
each other across the
longer faces of the
assembly as shown by
the green arrows.