Rover CS454R Series, Operator'S Manual

Page: 7 / 20

Assembly & Set-Up
3
7
Contents of Carton
• One Chipper Shredder • One Operator’s Manual • One Engine Operator’s Manual
• One Hopper Assembly • One Bag • One Chipper Chute
• One Chute Deflector • One Safety Glasses • One Bottle of Oil
Assembly
NOTE:
This unit is shipped without gasoline or oil in the engine.
Fill up gasoline and oil as instructed in the accompanying engine
manual BEFORE operating your chipper shredder.
Hopper Assembly
1. Remove six hex nuts and washers from the weld studs on
the impeller housing. Do not remove the support plate. See
Figure 3-1A.
A
B
C
Figure 3-1
2. Place hopper assembly into position in front of impeller
housing, aligning holes in hopper assembly collar with
weld studs. See Figure 3-1B.
3. Slide hopper assembly onto weld studs and replace
washers and hex nuts. See Figure 3-1C. Do not tighten
completely.
4. Lift hopper assembly up to impeller bracket assembly. See
Figure 3-2A.
5. Slide the release rod out slightly to hook the hopper
bracket onto the rod. See Figure 3-2B.
6. Tighten the six hex nuts that secure hopper assembly to
impeller housing and also tighten the hex nuts that secure
hopper bracket to hopper assembly.
A
A
B
B
Figure 3-2
Chute Deflector
1. Remove the wing knobs from each side of the lower
impeller housing. See Figure 3-3A.
2. Remove the hex lock nut, spacers, and hex bolt from the
top of the impeller housing. See Figure 3-3B.
A
A
B
B
Figure 3-3