STEP 4) Set stand to
square by measuring
diagonally.
STEP 5) Adjust until
both measurements are
equal then tighten
bolts.
STEP 6) Flip stand
upside down and insert
3” casters with rubber
mallet or hammer and
block of wood.
STEP 7) Return stand
to upright position.
Place saw to the rear of
shelf (for maximum
support area) and
center from side to
side.
STEP 8) Mark sites for
drilling.
STEP 9) Remove saw
from stand. Drill holes
in top using slightly
oversized bit.
STEP 10) Secure saw
to stand with bolts,
nuts, and washers(you
provide).
STEP 11) Adjust wing
height as needed to
bring level with
mitersaw base. This is
the only adjustment for
wing height.
NOTE!! Do not
tighten bolts at bottom
of wing supports.
Wing supports need to
be able to move freely.
If you have any questions please call us at:
1-(800)-635-3416
